@article {INOYATOV2011457,
	title = {Searching for influence of the {\textquotedblleft}atomic structure effect{\textquotedblright} on the KLL and LMM Auger transition energies of Zn (Z=30) and Gd (Z=64)},
	journal = {Journal of Electron Spectroscopy and Related Phenomena},
	volume = {184},
	number = {8},
	year = {2011},
	pages = {457 - 462},
	abstract = {The absolute energies of the KL2L3(1D2), KL3M2,3(3P0,2), and L3M4M5(1G4) transitions in Zn3067 from the EC decay of Ga3167 and from the β- decay of Cu2967 and those of the KL2L3(1D2) and L3M4M5(1G4) transitions in Gd generated in the EC decay of 153,155,156Tb fraction and the β- decay of 152,154,155Eu fraction as well were measured with use of the combined electrostatic electron spectrometer. The absolute energies of the KL2L3(1D2) and L3M4M5(1G4) transitions in Gd following the EC decay were found to be higher by 13.9{\textpm}0.9 and 16.3{\textpm}0.3eV, respectively, than those measured for the transitions initiated by the β- decay. Much lower differences of 2.1{\textpm}0.2, 2.4{\textpm}0.2 and 1.6{\textpm}0.2eV between the EC and the β- decay modes for the above mentioned transitions, respectively, were observed for Zn3067. Due to the uncertainties in the assumed chemical state of the studied isotopes generated by β- decay and EC decay in different sources, contributions from the induced chemical shifts of the electron binding energies to the observed differences can be significant especially in the latter case. Despite this fact the finding corresponds to the results obtained in the X-ray studies of the {\textquotedblleft}atomic structure effect{\textquotedblright} that the effect is the most pronounced for the 4f and 5f element groups. A comparison of the measured and calculated absolute Auger transition energies indicates that the electron configuration of Gd just after the EC decay can differ from that one supposed in the calculations.},
	keywords = {Auger effect, electron spectroscopy, Gd, KLL, KLM, L3MM transitions, Zn, {\textquotedblleft}Atomic structure effect{\textquotedblright}},
	issn = {0368-2048},
	doi = {https://doi.org/10.1016/j.elspec.2011.05.007},
	url = {http://www.sciencedirect.com/science/article/pii/S0368204811000867},
	author = {A.Kh. Inoyatov and L.L. Perevoshchikov and V.M. Gorozhankin and A. Koval{\'\i}k and V.I. Radchenko and D.V. Filosofov}
}
@inbook {1324,
	title = {Surface science studies of the effect of Mn2+ on zinc phosphating of 2024-T3 Al alloy},
	booktitle = {Aluminium Alloys 2006, Pts 1 and 2 - Research through Innovation and Technology},
	series = {Materials Science Forum},
	volume = {519-521},
	year = {2006},
	note = {ISI Document Delivery No.: BEZ41Times Cited: 1Cited Reference Count: 10Akhtar, A. S. Susac, D. Wong, K. C. Wong, P. C. Mitchell, K. A. R.Proceedings Paper10th International Conference on Aliminium Alloys (ICAA-10)JUL 09-13, 2006Vancouver, CANADABRANDRAIN 6, CH-8707 ZURICH-UETIKON, SWITZERLAND},
	pages = {753-758},
	publisher = {Trans Tech Publications Ltd},
	organization = {Trans Tech Publications Ltd},
	address = {Zurich-Uetikon},
	abstract = {The present work is part of a broader investigation of the effects of additives in zinc phosphate (ZPO) coating solutions that are designed for specific applications to Al and its alloys. ZPO conversion coatings improve the corrosion resistance of the Al substrate and increase the adhesion of paint. Coatings formed on 2024-T3 aluminum alloy, after dipping in ZPO coating baths containing Mn2+, have been studied by X-ray photoelectron spectroscopy (XPS), SEM, and scanning Auger microscopy (SAM). Variations are observed in coating morphology and composition as the amount of Mn2+ in the coating solution increases through the 0 to 2500 ppm range. Adhesion tests give information on the relative strength of the coating-substrate interaction at different microstructural areas.},
	keywords = {aluminum alloy, ALUMINUM-ALLOY, Auger, COATINGS, CONVERSION COATINGS, electron spectroscopy, Mn2+ additive, photoelectron spectroscopy, scanning electron microscopy, STEEL, zinc phosphate},
	isbn = {0255-54760-87849-408-1},
	url = {<Go to ISI>://000240309000118},
	author = {Akhtar, A. S. and Susac, D. and Wong, K. C. and Wong, P. C. and Mitchell, K. A. R.},
	editor = {Poole, W. J. and Wells, M. A. and Lloyd, D. J.}
}
